This massively powerful Talaria 72v battery which is an ebmx 72v 57ah has 150% more energy than the stock battery and will deliver all the thrills you could want. This Talaria sting battery upgrade will fit Talaria sting mx3 and Talaria sting r mx4 models.
Controller Note:
This ebmx 72v 57ah battery will require the use of a EBMX controller upgrade and will not run on the stock 60v controller. In addition, this battery will require a new 72v charger (click here for the 72v/15a Talaria Charger) and cannot be charged on the stock 60v charger.
Talaria 72v Battery Lid:
Please note, due to the increased capacity the Talaria battery lid is required. Do not worry this lids comes with the battery as a bonus!
Talaria 72v battery Usage Warning:
These high powered controller kits are intended for off road riding using on/off throttle, not continuous throttle applications. Modifying Talaria ebikes with these controllers and tunes make them illegal to ride on the road. After installing an aftermarket controller and getting a high powered tune, you are running the risk of damaging your motor. Even with motor temperature protection enabled, it is still possible to damage your motor if you push the motor outside of its limits. To ensure you do not cause damage to your motor, follow the advice below:
To ensure you have the safest and best riding experience when riding around wet areas, please ensure you follow the instructions below:
Ensure your motor controller is mounted such that the control connection plugs are at the top of the controller. Use dielectric grease for each of your electrical connectors, especially the ones going into the motor controller. Dielectric grease is meant to be used to help keep out water, dirt and contaminates, it is not to be used to fill up connectors entirely. Please watch some YouTube videos on the proper way to use dielectric great on electrical connectors if you have any questions. Ensure the brake sensor plugs are disconnected from the bike harness.
This can be done by cutting them at the brake levers, or just opening the ignition/USB charger cover and disconnecting the two plugs. Once an aftermarket controller is installed, these brake lever sensors will not work, however if water gets into the system and they are still connected, they are able to short circuit with other pins and cause unintended acceleration and other issues. Avoid riding in water wherever possible and do not use a hose or pressure washer anywhere near the motor controller when washing the bike.
Reviews
There are no reviews yet.